Any listing in this product directory or other related materials, where “NRTL” appears next to the product name was tested and is listed by ARL as an NRTL, consistent with the requirements of the NRTL Directive.  Other products are listed solely by ARL under its accreditation to ISO 17025 and ISO 17026.


The products listed here are low voltage landscape lighting systems and components that may consist of a power unit, wiring, and luminaire.  This category only covers equipment where the maximum output of each secondary circuit is 25 amperes, 15 volts AC (21.2 volts peak) open circuit voltage, 300 volt-amperes.  The equipment is intended to be installed in accordance with the National Electrical Code, ANSI/NFPA 70.

The luminaires covered by this category are intended for garden, walkway, patio areas, or similar outdoor locations and for certain indoor locations such as atriums and shopping malls.  The power units may be installed indoors or outdoors in accordance with the marking on the product.

Fluorescent and high intensity discharge lighting systems have been investigated in accordance with the applicable requirements for this category and with the applicable requirements in the Standard for Fluorescent Lighting Fixtures, UL 1570, and the Standard for High Intensity Discharge Lighting Fixtures, UL 1572, as appropriate.

Each product is marked with the name or trademark of the (manufacturer) or vendor, a distinctive type, style, model or catalog designation, date code, electrical ratings, electrical hazard warnings, wiring diagram, and other markings and cautionary warnings as required for specific types of products.

These products comply with ARL requirements which include pertinent sections of the Standard for Safety, ANSI/UL 1838, Low Voltage Landscape Lighting Systems.

A product that contains features, characteristics, components, materials, or systems new or different from those covered by the requirements of the standard, and that involve a risk of fire, electric shock, or injury to persons, have been evaluated using the appropriate additional component and end-product requirements as determined necessary to maintain the acceptable level of safety as originally anticipated by the intent of the standard.  A product whose features, characteristics, components, materials, or systems conflict with specific provisions of the standard have been judged to be in non-compliance with the standard.

Only products which properly bear the ARL Listing Mark (Label) are considered Listed by ARL.


Delisted products appear with a double strike through and “DELISTED” after the report number.
Deleted/revised models for listed products appear with a single strike through.



Listed Product Directory (revised 01.13.15)